Rob Faludi
Forum Replies Created
-
AuthorPosts
-
Rob Faludi
KeymasterWell the first question would be what was customized and does the code work pre-customization?
Rob Faludi
KeymasterI’m not familiar with that error.
Rob Faludi
KeymasterCould also be the cable. Remember the four blinks mean you’re not getting DHCP (most likely) so that could be a separate issue. It does tend to indicate that the chip is running normally, since the four blinks are being generated by the program.
Rob Faludi
KeymasterFour blinks mean you may not be getting an IP address via DHCP. We tried to reset the module but it timed out. (http://www.botanicalls.com/forums/topic.php?id=16).
If you are seeing “garbage” in the serial monitor it could be that you are looking at the wrong baud rate. First thing to check is to confirm that your serial monitor is running at 9600 baud.
Rob Faludi
KeymasterBotanicalls kits are manufactured and distributed by SparkFun Electronics. Simply contact them if you are missing any part of the kit: http://www.sparkfun.com/static/contact for a replacement part, or help in getting one from your regional retailer.
Rob Faludi
KeymasterWe’d check the power supply, and your solders around the power connector and the voltage regulator for starters.
Rob Faludi
KeymasterNo the correct path would be ~/Documents/Arduino/libraries/ArduinoEthernet/EthernetDNS/EthernetDNS.h
Check the library documentation linked to online.
Rob Faludi
KeymasterThis should work. It sounds like your path to the libraries is broken. What’s the current path to, for example, EthernetDNS.h ?
Rob Faludi
KeymasterDid you install the EthernetDHCP library as described in the Customize page? Double-check that, and if you’re sure you’ve got all the libraries where they should be, let us know which version of the Arduino IDE you are using.
Rob Faludi
KeymasterIn what way did the leaf board die? And is the issue with the light on the FTDI board or the Botanicalls board?
Rob Faludi
KeymasterThe current version of the code is 3.01. Download it from the code site. Any version older than 3.00 won’t work with the current kit.
Rob Faludi
KeymasterYes you can use v2.17_OAUTH code on that original leaf board. You’re good to go. The “to do” is for instructions only.
Rob Faludi
KeymasterThese are just bypass caps, so the values aren’t too critical. The larger cap will filter out lower noise frequencies, possibly most useful since there’s generally going to be a regulated A/C power supply connected to the regulator. However feel free to substitute other values if you prefer.
Rob Faludi
KeymasterKits are now available from SparkFun Electronics: http://www.sparkfun.com/products/10334
Rob Faludi
KeymasterNew kits are completing development and are scheduled for release this quarter.
-
AuthorPosts
New kits are here!
Categories
- Announcements (8)
- Press (5)
Pothos Plant Tweets

Flickr Feed
www.flickr.com
|
Meta

This work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 United States License.